Programming the Sno-Way ProControl™ Ensure vehicle bumper connection is made and the vehicle supply voltage is 12VDC. Also, verify that the 14-pin and 4-pin (when present) connectors are connected from the receiver module to the power unit. Start by putting the Sno-WayProControl™ transmitter into pairing mode by pressing the ON […]
Learn More >Ensure vehicle bumper connection is made and vehicle supply voltage is 12VDC. Also verify that the 14 and 4 pin (when present) connectors are connected from the receiver module to the power unit. A red blinking LED indicates the receiver has power and is not communicating with a transmitter. Turn […]
Learn More >Ensure vehicle bumper connection is made and the vehicle supply voltage is 12VDC. Also, verify that the 14-pin and 4-pin (when present) connectors are connected from the receiver module to the power unit. A red, blinking LED indicates the receiver has power and is not communicating with a transmitter. Turn […]
Learn More >Polycarbonate has extremely high impact strength, a low coefficient of friction, and is proven to efficiently roll more snow than metal blade skins. Polycarbonate will not corrode. Steel blade skins provide maximum value and exceptional strength.
Learn More >Abrasive or highly alkaline cleaners, acetone, carbon tetrachloride, benzene, leaded gasoline, or brake cleaner should NOT be used. These products will ruin the polycarbonate blade.
Learn More >Sno-Way recommends using soap and water or isopropyl alcohol to clean your Sno-Way polycarbonate snow plow blade skin.
Learn More >
